How to Load Victron's GUI-V2

If, like us, you're curious about Victron's latest firmware update for the the Touchscreen GUI and would like to try it out, the beta version of the firmware is available.

Note that it is a beta version so expect there to be some remaining bugs until the full, official version is released. 

To load Victron GUI-V2:

1. Go to settings on your Cerbo GX via the GX Touch while connected to an active internet connection.
2. Go to Firmware
3. Select Online updates.
4. Change the Update Feed from "Official Release" to "Beta Release"
5. Return to the previous page and select "Check for Updates"
6. The new Version of the Firmware ( 3.40~39 as of this writing) will be available on the bottom line. Tap to install it.
7. Await the installation / reboot of the Cerbo GX.
8. If your Cerbo doesn't load up with the new GUI check the "Display & Language" setting and check the "On Screen UI (GX Touch & Ekrano)" and change from the "Standard Version" to the "GUI-V2 Version.”

If you want to return to the "official release" firmware, simply repeat steps 4-7 choosing "official release" this time.